Standardize the operation and maintenance of bubble film machines

Bubble film machine manufacturing process: Through continuous research and development, independent innovation, the company widely absorbs technology from various countries around the world. The overall design of the bubble film machine has been studied, making it easy to use and effective. The bubble film machine can use raw materials: this equipment can be used to recycle LDPE and LLDPE plastics. Manufactured products can replace packaging products such as paper envelope bags, paper plastic composite packaging bags, and pearl cotton. Environmentally friendly, moisture-proof, and anti extrusion molding. Used for furniture, hardware, electronic equipment, mechanical equipment, etc. How to standardize the operation of our bubble film machine? Below is a brief introduction for everyone:

1. Ensure that there are no issues with automatic temperature control and the heater, and pay attention to adjusting the heating temperature at each point within the indicator range in a timely manner.
2. Check the traction speed and control the paint film thickness.
3. Observe and adjust the uniformity of film thickness to see if the bending diameter meets the standards.
4. Check the pressure of the gas cylinder. It shouldn't be too high, but it requires additional pressure.
5. Control the proportion of raw materials and mix evenly.
6. Check the raw materials for impurities. Especially ensure that the iron and magnet are mixed in a timely manner.
7. Check the position of the gearbox and the lubrication of the air compressor cylinder.
8. Regularly check the temperature rise of each motor during operation and the transmission of the bubble film machine.
What impact will the bubble film machine have on subsequent work after maintenance?
1. Check the power supply, vacuum system, pressure system and cooling system before each startup. After starting the equipment, check whether the rotation direction of each rotating component is correct. Pay attention to checking the lubrication condition of each lubrication part in daily life. Electrical instruments should be maintained normally according to regulations.
2. The equipment should be operated by a dedicated person, and the extruder screw should not be idle without material to avoid scratching the screw and barrel. After shutdown, if there are materials stored in the barrel, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements and maintained for more than 30 minutes before starting again. It is strictly prohibited to start before the temperature does not meet the requirements to avoid damaging the parts.
3. When feeding in the hopper, it is necessary to maintain cleanliness and strictly prevent metal debris, sand, and small tools from entering the feeding port to avoid damaging the cylinder and screw. If abnormal noise is found during operation, it should be immediately shut down for handling.